Is it possible to program a 97 Honda civic keyless entry after putting in a new stereo? - how to tell if my honda has a keyless entry
I replaced the stereo in my Honda Civic 97, and keyless entry does not work (I knew what would happen), but I had a Honda and other soldiers in the automotive industry tell me they can keyless entry, if the stereo old earth (I do not understand) to see the whole. In any case, it is, but nobody seems capable of keyless entry program (not to say that the printed instructions for a 97 Honda CR-V, which is not my car and noticed no one person, I was not there when it happened). In any case, I can program it?
Thursday, February 4, 2010
How To Tell If My Honda Has A Keyless Entry Is It Possible To Program A 97 Honda Civic Keyless Entry After Putting In A New Stereo?
1 comment:
The service people that you're saying is that if we replace the original radio with a radius of Honda, then you need to reconnect the original car radio with the remote program. This means that the connection of the radio power of 12 volts, ground and aerial. Who found this new radio should be able to do so. Works of keyless entry with a radio signal that sends to the control unit for the keyless entry, but in Civic this year the programming is done by a servant / Disarm button radio home. If the radio source was to not (no lights replaced), then you are lucky with remote programming, if you find another radio home, do it. Here's how Honda remote to the radio with the program of original
Channel programming
NOTES:
• The system accommodates up to four transmitters.
• Entering the programming mode breaks all learned
Transmitter codes, so that none of the above
Issuers of programs to work. You must
reprogram all transmitters, if you are in the
Programming mode.
1. Turn on the ignition (ii).
2. Keep the service Disarm
Radio button (between the
AM / FM / CD / cassette buttons) to
Enter programming mode.
(Keep clicking
During this process, or
Programming is terminated.)
Make sure that the door locks
Cycle to confirm that you are in the
Programming mode.
3. In 5 seconds, press the "block" or "Unlock"
Button on the transmitter. Verify that the power
Door locks cycle to confirm that the code
accepted.
4. Within 10 seconds, press the "block" or "Unlock"
Button in each of the other channels.
5. After all channels have been programmed
Service Release button to disarm the exit
Programming mode.
Post a Comment